Vinyl Cutter Download Graphtec FC, Vinyl Cutter Machine Download Software Installation & Operation Manual in pdf ( MB) > Download Now. Manually Adjusting the FC ARMS Sensor Level for Glossy Media and Glossy Laminated Prints. When using some glossy media or when using glossy. View and Download GRAPHTEC FC Series user manual online. Cutting Pro . FC Series Plotter pdf manual download.
|Published (Last):||25 September 2011|
|PDF File Size:||12.23 Mb|
|ePub File Size:||1.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
Assembly Assemble the left and right stand sides. Hold-down Force Assignments Hold-down Force Assignments Use the Strong or Medium setting for the push rollers used to hold down the edges of the media. See the User Guide for the provided software for details.
Do not allow small children to touch the plotter. Page 11 Chapter 7: Settings Regarding Operation Environment Chapter Setting of the Initial Down Force The initial down-force setting is effective when tangential mode is selected. Detection level will define the threshold to be placed at what percentage point of the signal level difference between the media background color and the mamual mark.
Attaching a Tool When mounting the tool in the tool holder, push the tool all the way into the holder until its flange contacts the upper part of the holder and then grraphtec the screw firmly. Either expand the cutting area, or set the media that is big enough to copy. Operation will stop and following screen is displayed. When the basket and Graphtec-specified media are used under certain condition settings.
ARMS (Advanced Registration Mark Sensing system)
Adjust The Blade Length Manually Adjust the Blade Length Manually Optimal cut is not achieved unless the blade length is adjusted in accordance to the used media and the cutter blade. Setting Registration Mark Size the size of registration marks to scan. T o prevent injury, avoid touching the tool immediately after the cutting plotter is turned on or whenever the tool is moving. Never attempt to perform repairs yourself.
Setting Length of the Overcut Set the length of overcut with tangential emulation. Please refer to the following list.
GRAPHTEC FC8000 Series User Manual
Automatically Cross Cut will automatically cross cut after cutting when the cutting is done with provided software. Contact your sales representative or nearest Graphtec vendor for repairs. Tool Offset Adjustment This is used when there is difference in cutting between 2 tools. Setting the Reference Angle The FC analyzes the cutting data, and controls the angle of the cutter blade tip if the change in the angles of the corner is large.
Press the media lock to engage it, and then pull the leading edge out of the front of the plotter so that it completely covers the media sensor. Input fc0800 initially same as measured value is displayed under that.
U sed to raise or lower the Push rollers during the loading or unloading of media. As the center of the line.
Repeat steps 3 to 5 and select the 4 fraphtec to be set. Press the  key CUT. Contact your Graphtec call center fc80000 the problem still exists.
Setting Regarding Cutting Quality There are times that ideal cutting may not be possible, such as the lines may shift, corners deform, or uncut sections occur, due to the characteristics of the media thickness, how hard it is, etc.
Page 11 Using the registration mark plotted in step 9, measure the Supplement distance of how much the comparison registration mark needs Position of the registration mark is measured at to be moved so both will overlap, and record the value.
Graphtec Manuals and Drivers – SignWarehouse Product Support
Settings of Controls from Co Adding special marks with Graphtec software is not necessary. Page Press the  key X. Supplement TOOL setting grsphtec is displayed. It cannot be retrofitted. Sorting the Cutting Data Cutting efficiency is enhanced if the cutting data are sorted so it will combine the cutting to make the time needed to move the media and exchange the fv8000 as less as possible. Check that the power is supplied to the electrical outlet.