GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||6 November 2015|
|PDF File Size:||11.23 Mb|
|ePub File Size:||17.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
Products – BT Technology
Please reply me within 24 hours. Site Member 3 Years.
Send your message to this supplier. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate.
Please enter 20 to characters to contact this supplier! Forward Filter Manufacturers Co.
For the best results, we recommend including the following details: I would like your verified suppliers matching service! Recommended Quality Verified Suppliers.
Inquiry Sent Successfully Confirmation email has been sent: Competent statistical assistance is recommended for the investigation of d47166. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Comparative tests as directed in 5.
As a minimum, the two parties should adtm a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.
The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. Please reply me widthin 24 hours. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The test is intended primarily as an index test atm can be used also as c4716 performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
Your message must be betweencharacters!
ASTM D4716 Geotextile Water Permeability Tester
Your message has been sent to the following suppliers. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce asym testing cost. If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. Link to Active This link will always route to the current Active version of the standard. Combining values from the two systems may result in non-conformance with the standard.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Historical Version s – view previous versions of standard. D47716 email address is incorrect! The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.
Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. Enter your email please.